Had this session were
going to model this desk as our practice or table, actually.
But here I'm going to give you some points about the table at first,
as you can see, the top phase is tapered and these are the legs of the table
which are straight, as you can see at both sides.
No, Dad, when you are learning some commands
and right now it is common between the learners that some of them
make the process of modeling too complex for themselves and complicated.
Actually, right now I want you to go through the easiest
and the quickest approach and method for creating such a table,
and then you can ignore the new learned command.
For instance, for the top phase of the table, I can use extra tapered.
I select the rectangle and then extrude tapered.
I choose chop for the corner.
I specify the angle to drive angle or even
I could draw another rectangle and and love them.
But if I did that it would be like this.
Check this out and then I hold down all turn shift.
I maximize your then creating a copy this way
and then I can see the distance between the two curves.
As you can see, it takes more time than before and previous method.
After that, we should capture openings.
Check this out.
So it did take a long time.
So extra taper is the easiest and quickest way here for creating your table
and for the legs that it could be somehow tricky that the cross
sections of the legs are not equal to each other.
One of them is greater than the another one.
So you may want to use tapered extra taper,
but as the two ends are straight, you can open the front for you
and then take curve and then enable the project.
And I also enable the greatest snaps following that checklist out.
For instance, this is
one of the legs of the table, and even I can
narrow the base of the leg like this way.
So right now we'll finish and then we extrude the curve.
Check it out.
By this way, as you can see, very down with the neck.
Following that, I did tab for you, I selected and then I position it.
Check it out.
Well done.
So it was very easy and there's there was no need to operate
more complex and special extrude commands.
I exemplified this case to show you that sometimes there's
no need to make the process complicated While we can move the process forward
at the most simple way, as most as possible,
I position the legs and I create a copy like this.
I rotate them down, shake it out guys.
However, we should modify the position of the legs
well down right now it's your turn.