OK, so now our program to the board, but I have to give connection, so let me do the connections
according to our program.
So here it is, four to one, right?
So what one has to be, what has to be interfaced of it, that common data lines of some segment display.
So I'm interfacing port one with the common data line that is the sound segment in.
So I am interfacing that actually.
That's OK.
So now nothing is dead in your displaced because you haven't been able to.
And you display so far that you have for controlling here for control.
Let me say, I just want to enable this particular line that is my need for that.
What I have to do is this line that this line segment one segment, one part that what I have to do
is I just have to connect the controlling here.
OK, let me connected.
I hope this is possible.
OK, Lynn, let me preface this, but if you can remember from my program, it has been our carrot zero
zero to be not not so as connected like this.
So now I have in our building control nine zero, which is nothing but the first segment here you can
see the first segment can see the first segment here, which is showing all the numbers from zero to
one with the delay of 50000 counts, right?
I hope this is a simple one two three four five six seven eight nine, right?
So that is how the numbers are getting displayed.
So the idea here is you are placing the data on board one that is given us common data to all different
segments, know all different segments will be receiving the same data.
But the idea here is you have enabled only first to segment one of the first segments connected to Port
zero zero.
So only that will be enabled if you want to can take the control lane.
Now, with this half and connected to the next two segments Control and that is Port One's Controlling
now that segment will be selected.
OK, that segment will be selected, right?
That segment will be selected.
I hope this is clear, but here, if you see, even if you connect the controlling for all the four
segments, the same data will be displayed, right?
Let me show you that out of here.
I have a visual display, so let me take taking output from this file display.
OK, so here I hold it up, Layla, let me give it to the.
Give it to some other segments.
See, for example, segment number two.
No, I have an appeal to both the segments.
OK, this is possible.
There is no need to give the control lines to your airports, if you will.
The idea is you have to make the control lanes to be highly rated.
You can also give it to defy.
You will be display if you want and give it to firework supply.
The problem here is if you give it to a firework display, then the control line will be enabled by
default.
You cannot actually switch it off one.
If you remove it, it will be switched off.
Otherwise you cannot accidentally stop.
It will be enabled by default.
But if you drive into the control lane with your board, then you can have a control over the lanes.
You can have a control over the lines.
No, both the segments are now built, as you can see here, but not only the same data as green displayed
on board segment.
This is a problem, right?
You just want to display some of the data on the.
A different place, right?
OK, so let me show you how to do that in the upcoming videos.
I hope this is clear.
The interface is clear.
Thanks a lot.