argon laser first thing we're going to
do is we're going to plug in the back of
plug in the machines both top and bottom
the scrub is going to hand off the end
to the circulator the patient will also
need a grounding pad
after all the cords are plugged in then
you'll open the gas in the back of the
machine
we will turn on the machines
we will set each machine
perhaps FFT for if for some reason it's
not setting have the scrub put it on
argon push it all the way and push down
and that will allow the circulator to be
able to set the settings laparoscopic is
saying before this is showing us that
our tanks are full and this we're going
to set to between 5 and 7 the scrub will
now set up the handpiece this can be
done simultaneously while the circulator
is plugging in all of the wires before
the machines are turned on we're going
to make sure that this little switch
right here is turned to argon ar this
can be used as a Bovie as well when the
switch is in the the back position you
can use it as a regular building and now
we're going to touch the handpiece you
want to test against a shiny reflective
surface it's working properly and so now
we can hand it off to the surgeon
beautiful