This video I will explain the matter to Ed then Venetian leaders are the mesh in the monitor here and
here I am going to add the bottom layer on the wall which is a small pipe and this pipe so the balsa
wood would be generated normally to these walls and this would be used to the logs.
The bottom layer of the floor in these areas and to air the inflection layer either you can again go
from this manual from here.
You can also right click on the mesh and insert and from here to the inflation
and we reduce the geometry first which is this whole body because the surfaces on which I will create
an impression is also part of this whole volume body and apply.
And now I have choose the night.
Now I have produced the geometry after some places where I want to clear the information layer.
So this is a flat surface.
Second third there is a far large pipe and this is far a small pipe and inflation layers will be created
normally to these walls apply and just keep the default option here first.
And after creating the inflation layer we will adjust these but I mean guess if needed.
And here I am going to create the mesh so click on the i then generate order with the update.
So click on gendered for example here
so here you have created the inflation layer.
And if I click on domestic fails remove the section from the geometry and you can see that we have the
five years and that will be able to resolve the only a small and the incoming machine which are defined
and media measures.
I would create a more number out for NRA layers in the model year and also you can observe the other
as the number of cells are the our size our sensors decreasing numbers still increasing in some region
and so the height of 10 freshman year depends on the the best triangle or the best triangle has a smaller
base so the Hydra we are the smaller so try to keep the mashing in the best aspect to show off the despair
zone.
These are presumably as and if we take a look on here you can see that the option we secured is a smooth
transition.
You can also use techniques that is taken out this volunteer and you can also use the option firstly
connect for example I want to define the layers of layer height as a point double zero 1.
So the first layer will be off the height.
This firstly I would be all height point double 0 1 and next layer they will grow adoration the rate
out of one point 1.0.
So next layer will be all the size.
Point 0 0 1 2.
Next one would be the point zero zero 144 and so on.
And if I choose let's say instead of point zero one point w the one I am just using the point zero one
I now again generate.
You can see there that the size is now changing and also one more than you can you can observe here
that as we fixed the fossil height and so it is not adjusting the this height of the present based on
the height of the ah the triangular base.
So it is giving you creating informally the same size and soda these sizes are different father.
So even for the triangle with lower base size are the age under the on the geometry it is is still creating
same size under in the height.
So I will just again take it back to the default condition that is the that is the small donations.
So this somewhat our nation will try to clear the best part of the major parties GMAT and for any other
geometry
so here we have a smooth transition you can see
Okay so this is all about the inflation layer and expertise I will.
I will die.
I will discuss about the body sizing.