As I mentioned before,
you're back to right now into the front for you.
I will not draw these two curves because this can help me to control
the proportions and the dimensions of the arc from the original point.
Right this way.
And then for the approximate dimensions
by this very small track.
Check it out.
Well done.
Like this way.
I mean, at the end points, as you can see, we've got the arc.
Let me show you the photo. Check it out.
Therefore, here
I pick the arc and then from the end
I started then at the right view.
And then according to the picture
and the approximate dimensions or sizes.
And then I draw this check it out.
By this way,
look,
so serve you're done with the first arc,
which is started from the ground that I'm showing.
And here we get a straight curve.
Let us, draw the most important bones.
Smarttrack just straight curve like this.
Let me create a cup from this
to position it at the other ends of the curves.
And then we need two more arcs
just here with as light slide.
Continue it
back to right now.
And then from this point, take it out like this.
We end and the third point at the top view
to control the continuity of the arc.
Let me adjust it
and then I specify point an arc
y this way.
Well, Don, then here, as you can see
the arc, he's getting aligned with this curve.
I mean, it should not be straight like this.
It should be aligned with this slanted curve.
Am I right?
So here at the right view front,
I select the curve and then rotate and then I align it.
We see curve like this way. Check this out.
Following that, I want to do all the next curve that I'm going to.
I started from the midpoint, so here and right now arc
and then from the midpoint, check it out.
Then I specify the point on ARC.
Watch this at the top of you and then I draw it like this way
well down.
Following that, I should rotate the curve.
Look, as he can see, the arc should be rotated in order to consider the angle.
So a different view.
I select the arc and then rotate.
Following that, I rotate it like this way by specifying points.
Check it out, we're almost done.
Then let us try.
And then I start D two in curves and if it was any problem,
we can revise it right now.
If got these curves.
And then it's time to use twin curves.
Take it out in curves, I select these curves that I specify the number.
For example, seven to show what a preview seven is.
Okay, Inter.
And then the other curves will don.
And then these two check it out.
Like this way
grade.
Following that, we should pipe down,
right click on multiple.
Then I select the curves, press down into and then I specify
the radius not point to Let's take it out at the render viewport.
You reach the final result.
It's your turn to give it a try.