Install the COM driver
Select and DoubleClick folder "Pressure gauge"
Select and DoubleClick folder "Pressure gauge software"
Select and DoubleClick folder"Silicon_CP210x_VCP_6610_32bit"
Click “CP210xVCPInstaller_x86”
Click Next
Click "Finish"
COM port confirm
Rightclick "My Computer" to select "Device Manager"
Click "Port" to review the COM port assigned by PC
Connect the cable，check the COM port assigned by PC
Gauge Operation Part
Connect the gauge and PC
DoubleClick fold "Pressure gauge software"
DoubleClick "HSPPGauge"
Click "Communication Port" to change the port to the one assigned by PC
Click "Connection Test"
Click“Tools Identification”
Click“Data Reading Start”
Display the current temperature, pressure, working volt of the gauge
Gauge's status is ok
Click“Stop”
Click“Exit”
Gauge working time table
Click“Time configuration”
et the gauge working time according to the acutal requirements
For example
Click "Tool Operation" to write in time table
Read time table to confirm the sucessful write-in of above mentioned time table
Click “Exit”
The battery can be connected to perform well logging simulation
Connect the guage and battery, connect the battery housing after the battery indicator flashes 3 times
Connect the battery housing
Well logging simulation is over, remove the battery
Now download the data from gauge, connect the gauge and PC
Select COM port
In case of failure, re-connect the communication cable
Select“ Data Process”
Click "Tool Operation" to read gauges
Input Well No., click save
Simulate logging data
Display the current temperature, pressure, working volt of the gauge
Press left button of mouse on the curves to amplify
Click right button of mouse and select "Fresh" to reset the curves
Click “ Exit”
Click “Data Process”to enter data process UI
Click "File Operation" and select "Open Sampling file" to review previous log data.
and log data saved previously.