Method method used to connect Raspberry Pi to Apple Computer is to use a network cable, so as you can
see in this picture, here's our laptop, here's the network standard cable connected to our spirit
by here is that's the card.
And the bars apply for the Raspberry Pi.
Steps are to do the steps to do this is really simple, so just go to and remove the last Bellambi from
the electricity and connect the car to your computer using.
That's your spouse, the card reader.
You will get the name boat, as you can see here, and enter the boat folder.
You will find out for alongside this this, uh, uh, hard drive, which is our as the card, uh, open
the system, the line, the text which has the start up sitting for the better by head to the end of
the file and uh the network be as follow I.B. equals one hundred ninety two hundred sixty eight one
ten.
After finishing the editing save the file and reattach.
That's the card the rasberry by.
By doing this, you assigned us better by this IP address, so the beginning or the start of the rasberry
by it will automatically assign itself to this IP address.
Now we will give the computer an IP address to do this, um, attach the rasberry body to the computer
using the network better than any other networks.
Things go to the Ethernet properties, then click on abnormalities like their go to Internet protocol
version for then use.
And remove the opt in automatic I.P. address and click on this one, right?
These informations, 109, 266 to one five.
This will enter itself once you click here and re-enter the same IP address here and here.
Here are the configurations.
Once done, click, OK.
OK, um, now you are assigned a fixed IP address to your computer.
Now you can connect to the board using BOTY or we can see if you are, uh, just around Bothy or B and
C if you are and write the IP address that you are assigned here, 109 to 268, 110, and you will be
able to connect the dots better by easily.
But no, that will this will cause a problem to your Internet connection.
And you need to reset the network settings once you finish working with the board so that your computer
can get an automatic IP address from the Internet provider or from the Internet browser.
So this method, this method has one downside, which is the fact that you might lose your Internet
connection, uh, and you need to reconfigure the Internet settings each time you attach and detach
that aspect about your computer.
I wouldn't recommend using this method, but I'm teaching you how to do it anyway so that you will be
familiar with each and every method used to connect better by to a computer.
Thanks for watching.
If you have any questions or feedback, please do provide it in the comments or review.
Of course, this is also at home.
Thanks for watching again.