Once so your taking boards could then it's time to start assembling the plantar type.
Two pieces a 40 centimetre decking boards and two pieces of 36 centimetre decking boards
ten or four pieces upside down
then make sure everything is lined up perfectly
you will want to take your time with each step it will be tricky since these are the first pieces to
be joined together.
Make sure all the edges are in line with each of that before you start screwing them together.
Once you're happy with the positioning we are going to screw the first 40 centimeters solid decking
boards to the support legs in the position you can see in this picture.
The positioning of the Screws does need to be precise but does grew too close.
The age of the boys as this might cause them to split.
Make sure as you are screwing through the decking boys that you are holding them tightly so they don't
move will slip out of position screen all four screws on the first side.
Then double check that the opposite side is all in position ready for the next screws.
The next step is to test the other side of the leg.
So take another 36 centimeter decking board and place it upright alongside the one completed leg once
again make sure it is all nice and flush bring your pieces close to the edge of the table so you can
easily screws through the side of the leg and into the document was behind.
We are going to screw these two screws in the bottom groove of the decking board if your decking boards
are different to mine than you may need to adjust these and then screw straight through into the lake
behind this group was growing through the third groove and We angled down slightly.
So he screws into the 40 centimetre side decking board behind.
This will give you extra stability
unscrew the screws in a little bit first before screwing the side are gone.
This will just make it a little bit easier.
Remember to screw this one down at a slight angle.
That is one corner complete
repeat the same process on the opposite corner of the same side and you will end up with one side that
will stand upright like this.
If you end up with any gaps where the legs join the sides then don't panic.
All you have to do is log your piece back then loosen off all the screws on the back of the one side
then unscrew and re screw in the leg screws before returning the back screws again.
You will find that this will then pull the leg in tighter and close up any gaps
complete a second identical copy of the solid you have just created and your plan 2 is now halfway to
being complete.